Home arrow CEMS Equipment arrow Configuration with one Counting Gas Cylinder
Home
Configuring a Spectrometer
MB Velocity Transducers
Mössbauer Drive Units
Digital Function Generators
MB Velocity Calibrator
Data Acquisition Units
Low Temperature Equipment
High Temperature Equipment
CEMS Equipment
Data Evaluation Software
Power Supply
Mechanical Setup
Mössbauer Sources
Radiation Protection Devices
High Velocity Drive Systems
Our Support on Location
Contact
Downloads
Imprint
Print E-mail
CEMS
 Configuration with one Counting Gas Cylinder

Configuration

SECURITY BALLOON

BUBBLE COUNTER

VALVE FOR LIQUID N2

PRESSURE REGULATOR

HSB-240-0105

VERTICAL BENCH CONFIGURATION

RIKON-5 LNC CONTROLLER 772

GAS MIXING UNIT

DEHYDRATION UNIT

Above figure shows the complete configuration of a low temperature CEMS* equipment. The required components - in addition to the standard Mössbauer system - are listed on the following table. The source for the counting gas is a gas cylinder with a ready for use gas mixture. The walls of the connecting tubes for the counting gas should be impermeable to water vapor. A pressure regulators - to reduce the high pressure in the gas cylinder to a manageable value - is not included in the delivery, but can be optionally ordered.
The gas cylinder can also be supplied by us, however it cannot be transported in an aircraft.

* Conversion Electron Mössbauer Spectroscopy

RiKon-5 TT includes Notes

RiKon-5 CEMS Detector

Placed inside the RiKon-5-LNC

RiKon-5-LNC Liquid N2 Cryostat

 

RiKon-5-LNC controller 772

 

Liquid N2 level sensor

With cable and connector, sensor placed inside RiKon-5-LNC

Security balloon

 

Gas dehydration unit

Delivered without the dehydrating chemicals

Bubble counters

Delivered without oil filling

Connecting tubes for counting gas

Made of TYGON/SCHORE 55
 
© 2017 WissEl - Wissenschaftliche Elektronik GmbH
Joomla! is Free Software released under the GNU/GPL License.